FAQ

Testing remote-controlled sockets

  • Connect controller with the app or browser
  • Enter “Settings” and then “AC sockets” and “Manual-/Testmode”
  • Push the button for 4-5seconds and the click the “ON” button of the corresponding component (e.g. the socket where you later plug in the light, must be programmed with the “ON” button next to the lights symbol and so on). You can click several times on the “ON” button to assure the signal is sent to the remote-controlled socket
  • When you hear a “clicking” sound you are done
  • Test each remote-controlled socket by switching it on and off. You should hear a the “clicking” sound when it switches. Feel free to plug in a device to see if the device get power supply

Programming remote-controlled socket

If you want to program the remote-controlled sockets on your own, please follow the next steps:

  • Reset the remote-controlled sockets first
  • Connect your controller to the app as described above
  • Enter programming mode in your app (Enter “Settings” and then “AC sockets”)
  • Follow the Connection Wizard

Manual programming:

  • In case wizard fails or if you want to test the connection enter (Manual-/Testmode)
  • Push the button for 4-5seconds and the click the “ON” button of the corresponding component (e.g. the socket where you later plug in the light, must be programmed with the “ON” button next to the lights symbol and so on). You can click several times on the “ON” button to assure the signal is sent to the remote-controlled socket
  • When you hear a “clicking” sound you are done
  • Test each remote-controlled socket by switching it on and off. You should hear a the “clicking” sound when it switches. Feel free to plug in a device to see if the device get power supply

Reset of remote-controlled socket

When you reset the remote-controlled sockets you have to program them again (see next question). Push the button for at least 6 seconds until light is red.

Status-Codes on Controller

Please see quick guide for detailed information.
RED – Error: Controller should reset automatically. In case it does not, please unplug and plugin the controller manually
Green-Yellow: Booting or Updating of the controller – Do not remove power supply
Green-Blue: Controller is connected with another device. You can use this the check values or adjust the settings
Green: Everything is ok. Controller is on and working

What does light utilization mean?

This value gives you an idea on the time your light is on during day light cycle. 50% would mean your light is half of the time on (e.g. when your light cycle is 16h on and 8h off, the light would be on for 8h). This value indicates if your setting or your setup fit well together, because the target is 100% and when it is below you might have a too strong light or your settings (e.g. hysteresis) aren’t at an optimum. Please see question “Why does the light is off although it should be on” for more information.

What are these climate pre-sets?

There are several kinds of climate pre-sets you can choose. Depending on the size of your plant you can choose the appropriate program. Please be aware that we use just general settings fitting for the majority of plants, but inform yourself if the setting fits to the plant you want to grow.